Electrovaya SC800 Instrukcja Użytkownika Pobierz pdf (Strona 22)

Chapter 3: Getting Started

3.1 Connect the AC Adapter

An AC Adapter is included in the box with your Scribbler. Use this adapter

whenever you want to charge the battery or when you want to operate from AC

power. The Scribbler must be charged before you can operate it solely on its

battery pack.

The AC adapter can be connected to any power source supplying 100 to 240

volts at 50 to 60 Hz (cycles). Its power cord can be unplugged and replaced with

a different standard cord, available in local computer shops, to accommodate the

different types of plugs used in different countries.

• Connect the power cord to the AC adapter and plug it into an AC outlet

• Connect the AC adapter’s DC plug to the AC Adapter port on the

bottom panel of the Scribbler.

Warning

Using the wrong adapter could damage your Scribbler, and even be

dangerous. There are many different sizes of DC plugs, different DC

voltages and different polarities in use in electronics equipment. While

AC adapters look very similar to one another, plugging in the wrong

adapter can break the AC adapter jack or its pin, can damage the

Scribbler circuitry, and might cause smoke or fire. Do not use airplane

power accessories. Electrovaya assumes no liability for any damage in

such an event.

3.2 Turn on the Power

• Make sure all external devices (such as the AC adapter, if you plan to

use AC power rather than battery power) are properly connected and

ready.

• If an optional external disk drive is connected, check that the drive is

empty.

• In the upper right hand corner of the Scribbler is a power-key hole.

Press your stylus into the power-key hole for a moment. The power

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 58 59

Brak uwag

Electrovaya SC800 Instrukcja Użytkownika Strona 22